2382 KB28 KB199920252013Avcu, EgemenKarabay, SedatOkutan, EdaSinmazçelik, Tamerštevilka:2letnik:59str. 97-105, SI 18ISSN:0039-2480COBISSID:13070107URN:URN:NBN:SI:doc-959C9PK9enAssociation of Mechanical Engineers and Technicians of Slovenia et al.Zveza strojnih inženirjev in tehnikov Slovenije et al.Strojniški vestnikdrill torqueempirical equationempirična enačbaGFRPglass fiber reinforced polymermachinabilitymorfologija površineobdelovalnostpotisna silasteklena vlaknasurface morphologythrust forcevrtalni navorA study on the derivation of parametric cutting force equations in drilling of GFRP composites|The aim of the present work is to derive machine force equations in the drilling of 0°/+45°/90°/45° oriented glass fiber reinforced polymeric matrix composites (GFRP). The novelty is in the use of the Shaw and Oxford model, which was initially developed for metals, for GFRP composites. The machining was performed on the GFRP samples using 118° point angle drills under dry conditions. During machining, drill torques and thrust force fluctuations were recorded using a dynamometeramplifiercomputer combination with different feed rates and drill diameters. The collected data were then analysed using mathematical models to investigate the empirical relationships between the essential parameters. The cutting forces in the drilling of GFRP materials were calculated using empirical equations and the results were compared with the measured data to verify the accuracy of the derived equations for the drilling of glass fiber reinforced polymer matrix materials. Moreover, the whole surface morphology of the drilled GFRP samples was examined by optical microscope and scanning electron microscope (SEM)TEXTznanstveno časopisjejournalsSlovenian National E-content AggregatorNational and University Library of SloveniaUniverza v Ljubljani, Fakulteta za strojništvo