207 KB18 KB200020242013Baručija, BesimBeganović, OmerMuhamedagić, SulejmanOruč, MirsadaRimac, Milenkoletnik:47številka:5str. 665-668COBISSID:1021610ISSN:1580-2949URN:URN:NBN:SI:doc-LOK4RJ2OenInštitut za kovinske materiale in tehnologijeMateriali in tehnologijedeformacijakarakterizacija materialovmaloogljično jeklostiskanjeInfluence of thermomechanical processing on the cold deformability of low-carbon steel| Vpliv termomehanske predelave na hladno preoblikovalnost maloogljičnega jekla|The group of steels intended for the production of bolts and nuts from the production programme of the Zenica Steel Plant, Zenica, nowadays called Arcelor Mittal Zenica, includes, among others, the steel C8C according to EN 10263-2. In this paper, the results of testing the above-mentioned steel, with the nitrogen content of more than 0.007 %, manufactured within a specifically defined technological programme, are presented. The testing of the rolled bars with a diameter of 12 mm is focused, among the mechanical and metallographic tests, especially on the technological compression test in the cold state that is normally performed as an additional control test in the production. The cold compression of the test samples has been performed in four degrees of deformation and at two different speeds of compressing tools. We determined the dependence of the resistance to deformation of the material on the degree and speed of deformation. The surface inspection of the tested samples was performed with visual control with the aim to determine deformability of the bars produced in this waySkupina jekel, namenjena za izdelavo vijakov in matic iz proizvodnega programa Železarne Zenica iz Zenice, danes Arcelor Mittal Zenica, vsebuje med drugim tudi jeklo C8C, skladno s standardom EN 10263-2. V članku so predstavljeni rezultati preizkušanja omenjenega jekla z vsebnostjo dušika več kot 0,007 %, izdelanega po posebni tehnologiji. Preizkušanje valjanih palic premera 12 mm je poleg metalografskih in mehanskih preizkusov usmerjeno predvsem na tehnološki tlačni preizkus v hladnem, kar se navadno izvaja kot dodatni kontrolni preizkus v proizvodnji. Preizkus hladnega stiskanja vzorcev je bil izvršen s štirimi stopnjami deformacije in pri dveh hitrostih stiskanja. Določena je bila odvisnost med odpornostjo proti deformaciji materiala, stopnji deformacije in hitrosti deformacije. Ocena površine preizkušancev je bila izvršena z vizualnim nadzorom z namenom, da se ugotovi deformabilnost palicTEXTznanstveno časopisjejournalsSlovenian National E-content AggregatorNational and University Library of SloveniaInštitut za kovinske materiale in tehnologije