2579 KB0 KB199920252021Bhatia, AnmolWattal, Reetaštevilka:6letnik:67str. 311-321ISSN:0039-2480DOI:10.5545/sv-jme.2021.7203COBISSID_HOST:69842435URN:URN:NBN:SI:doc-HRNJT6ETenZveza strojnih inženirjev in tehnikov Slovenije etc.Strojniški vestnikANOVAfriction stir weldingjeklometoda odzivnih površinmicrohardnessmicrostructuremikrostrukturamikrotrdotamorfologija lomaporušitvena natezna trdnostresponse surface methodologysteeltorno varjenje z gnetenjemultimate tensile strengthProcess parameters optimization for maximizing tensile strength in friction stir-welded carbon steel|The present study focuses on improving the ultimate tensile strength of friction stir welded carbon steel (AISI 1018). The effect of the process parameters (welding speed, tool RPM, and shoulder diameter) on the response parameters (ultimate tensile strength, percentage elongation and percentage reduction in area) were studied. Response surface methodology was used to develop the mathematical model for response parameters, and the adequacy of the model was checked using analysis of variance (ANOVA). The welding speed and tool RPM were found to affect the ultimate tensile strength significantly. The percentage elongation was affected only by welding speed. The percentage reduction in the area was affected by welding speed and shoulder diameter. The microstructure and microhardness of the weld have been studied and reported in the studyTEXTznanstveno časopisjejournalsSlovenian National E-content AggregatorNational and University Library of SloveniaUniverza v Ljubljani, Fakulteta za strojništvo